Proper acclimation is the key to successful introduction of new aquarium arrivals. The Floating Method is undoubtedly the most widely practiced method among hobbyists. However, a more exact method of acclimation provided by the Drip Method is required for fish, corals or invertebrates sensitive to sudden changes in water chemistry.

Why Acclimate?

The reason why acclimation is necessary is simple: the chemical makeup of the water in which the aquatic life is packaged is different from your aquarium water chemistry (i.e. water temperature, pH, and salinity). Aquatic life such as fish, and especially invertebrates (including corals), are very sensitive to even minor changes in water chemistry. The goal of acclimation is to gradually introduce your new aquatic life to the water chemistry found in your aquarium at a controlled rate to avoid distress.

The acclimation process is complete when equilibrium is reached, where the temporary container housing new arrivals shares the same water chemistry as your aquarium, and your new arrival appears adjusted to these conditions. Since different species have varying levels of tolerance, different methodologies are required to control the rate of change experienced during the acclimation process.

We recommends employing the Floating Method or the Drift Method of acclimation. The Floating Method of acclimation, where aquarium water is added to the floating bag in 1/2 cup increments, is a great choice when acclimating most types of aquarium fish. However, for more sensitive fish, invertebrates, and corals, it is recommended to employ the Drip Method of acclimation. Keep in mind, no matter which acclimation method you choose, be sure to take your time and never rush the process.

 

Floating Method

1Float Method Step 1Turn off aquarium lights.
2Float Method Step 2Dim the lights in the room where your specimen bags will be opened. (Severe stress or trauma may result from sudden exposure to bright light.)
3Float Method Step 3Float the sealed bag in your aquarium for 15 minutes. This allows the water in the specimen bag to adjust slowly to the temperature in the aquarium.
4Float Method Step 4After 15 minutes, cut open the bag just under its closure and roll the top edge of the bag down one inch to create an air pocket within the lip of the bag. This will enable the bag to float on the surface of the water.
5Float Method Step 5Add 1/2 cup of aquarium water to the bag.
6Float Method Step 6Repeat Step 5 every four minutes until the bag is full.
7Float Method Step 7Lift the bag from the aquarium and discard half the water from the bag.
8Float Method Step 8Float the bag in the aquarium again and proceed to add 1/2 cup of aquarium water to the bag every four minutes until the bag is full.
9Float Method Step 9Net aquatic life from the bag and release into the aquarium.
10Float Method Step 10Remove the filled bag from the aquarium and discard the water. Never release our water directly into the aquarium.
11Float Method Step 11Keep your aquarium lights off for at least four hours after the specimens are introduced into the aquarium to help them further adjust.

 

Drip Method

The Drip Method is considered more advanced. It is geared toward sensitive aquatic life such as snails, corals, shrimp, sea stars and wrasses. You'll need a drip acclimation kit (sold separately) and must be willing to monitor the entire process. Gather a clean, 3- or 5-gallon bucket designated for aquarium use only. If acclimating both fish and invertebrates, use a separate bucket for each.

1Drip Method Step 1Turn off aquarium lights.
2Drip Method Step 2Dim the lights in the room where your specimen bags will be opened. (Severe stress or trauma may result from sudden exposure to bright light.)
3Drip Method Step 3Float the sealed bag in your aquarium for 15 minutes. This allows the water in the specimen bag to adjust slowly to the temperature in the aquarium.
4Drip Method Step 4Carefully empty the contents of the bags (including the water) into the buckets, making sure not to expose sensitive invertebrates to the air. Depending on the amount of water in each bag, this may require tilting the bucket at a 45-degree angle to make sure the animals are fully submerged. You may need a prop or wedge to help hold the bucket in this position until there is enough liquid in the bucket to put it back to a level position.
5Drip Method Step 5Use the acclimation kit to set up and run a siphon drip line from the main aquarium to the bucket. You’ll need separate kits for each bucket used. The rigid tubing will sit over the trim of most glass aquariums. Use the enclosed valve to regulate flow from the aquarium into the bucket.
6Drip Method Step 6Begin a siphon and when water begins flowing through the tubing, adjust the drip rate using the control valve to a rate of about 2-4 drips per second. Water volume in bucket will double about every 1/2 hour.
7Drip Method Step 7When the water volume in the bucket doubles, discard half and continue the acclimation process until the volume doubles once more – about one hour.
8Drip Method Step 8At this point, the specimens can be transferred to the aquarium. Sponges, clams, and gorgonians should never be directly exposed to air. Gently scoop them out of the drip bucket with the specimen bag, making sure they’re fully covered in water. 
8Drip Method Step 9Submerge the bag underwater in the aquarium and gently remove the specimen from the bag. Please make sure that the water in the bag is from your aquarium, NOT OUR WATER. Also, to avoid damage, please remember never to touch the "fleshy" part of live coral when handling. 
10Drip Method Step 10Keep your aquarium lights off for at least four hours after the specimens are introduced into the aquarium to help them further adjust.

Important Tips:

  • Be patient – never rush the acclimation procedure. The total acclimation time for your new arrival should take no longer than two hours.
  • Always follow the acclimation procedure even if your new arrival appears to be dead. Some fish and invertebrates can appear dead when they arrive and will usually revive when the acclimation procedure is followed correctly.
  • Never place an airstone into the shipping bag or bucket when acclimating your new arrival. This will increase the pH of the shipping water too quickly and expose your new arrival to lethal ammonia.
  • Keep aquarium lights off for at least four hours after the new arrival is introduced into the aquarium.
  • Most invertebrates and marine plants are more sensitive than fish to changes in specific gravity. Please acclimate invertebrates to a specific gravity of 1.023-1.025 or severe stress or trauma may result.
  • Some live corals produce excess slime when shipped. After the acclimation procedure is followed, hold the coral by the rock or skeletal base and gently shake the coral in the shipping bag before placing into the aquarium. To avoid damage, please remember never to touch the "fleshy" part of a live coral. Many species of coral will not open for several days after introduction into their new home.

In some instances, a new tank mate will be chased and harassed by one or all of your existing tank mates.

Solution 1: A clean plastic spaghetti strainer (found at a local store) can be used to contain a tank bully within the aquarium for several hours until the new arrival adjusts to its surroundings. Just float the perforated plastic basket in the aquarium. Net the tank bully and place in the floating basket for approximately four hours while the new arrival adjusts to your aquarium. Never place the new arrival in this basket; the new specimen must get familiar with your aquarium. By placing the tank bully in a perforated basket, you’ll reduce the stress on the new arrival.

Solution 2: A perforated plastic lighting grid can be purchased at the local hardware store to cut down the width of your aquarium. This grid may be used to section off a small portion of the aquarium to separate territorial or aggressive fish from the newest tank mate.